Hudson-robotics Bar Code Print and Apply Manual do Utilizador descarregar pdf (Página 17)

Print and Apply User Manual Hudson Robotics, Inc.

6. Press the (Next-Save) button until the tear off setting is displayed,

using the (+) and (–) buttons move the label until it is in the correct

location.

7. Remove that label and press the feed button again 2-3 times to confirm

the proper tear off location.

8. To save the tear off position press the (Setup-Exit) button, this will

send it to the save options, the first option will be Save Permanently,

press the (Next-Save) to accept the save command.

9. After the settings have been saved correctly the printer will

automatically go back to Main screen, where it shows Printer Ready.

*The tear off position may need to be adjusted if the media is removed to clean the

printer or when a new media/ribbon roll is installed.

** Must allow 25 labels to be printed trough the printer when a new roll is installed,

since it needs time to find its natural resting location.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Sem comentários

Hudson-robotics Bar Code Print and Apply Manual do Utilizador Página 17