Hudson-robotics Dried Blood Spot Processor Manual do Utilizador

DBS USER MANUAL 10 Stern Avenue, Springfield, NJ 07081 Tel: 973-376-7400  Fax: 973-376-8265

DBS Processor Page 8 Step 2: Plug the 3 prong computer power cable into the AC wall outlet. Step 3: Plug the 3 prong processor power cable into

DBS Processor Page 9 1. Factory Calibration Method Step 1: Properly connect all cables and power-up the machine as described in Sections III.A.

DBS Processor Page 10 positions. To re-calibrate the remaining plate wells and save all calibration data, select Yes.

DBS Processor Page 11 SECTION IV Troubleshooting A. Problem/Cause/Solution 1. Processor  DBS rocker switch does not light when switched o

DBS Processor Page 12 Solution: Clean punch and around punching area. 4. Barcode  Barcode reader does not work. Cause: The computer is not co

DBS Processor - Table of Contents Page i TABLE OF CONTENTS SECTION I ...

DBS Processor Page 1 SECTION I INTRODUCTION The Hudson Dried Blood Spot Processor (DBS) links the barcode identification of a sample (a dried b

DBS Processor Page 2 SECTION II PROCESSOR OVERVIEW A. Hardware Part Name Part # Peripheral Equipment footswitch (1) ...

DBS Processor Page 3 B. Software 1. Main Screen The Dried Blood Spot Testing System boots up to display its main screen as show below. The

DBS Processor Page 4 This button allows the user to change the start and stop wells for the run as well as the order in which wells are processed

DBS Processor Page 5 3. Calibration Screen The calibration screen displays a plate map indicating the calibration points for a microtiter plate,

DBS Processor Page 6 The Calculate Plate button will recalculate all well positions based on the calibrated locations of wells A1, A12, H1, and H1

DBS Processor Page 7 SECTION III Machine Operation A. Start-Up 1. Cable Connections Computer - connect the computer power cable. Mouse - c